DATA TECHNOLOGY CORPORATION
DTC5280I, DTC7280
|
|
Data bus: 16-bit, ISA
Size: Full-length, full-height card
Hard drives supported: Two MFM ST506/412 drives
Floppy drives supported: Two 360KB, 720KB, 1.2MB, or 1.44MB
Interface: DTC5280i: 2:1
DTC7280: 1:1
|
CONNECTIONS | |
|
Function |
Location |
|
34-pin control cable connector-floppy drive |
J1 |
|
34-pin data cable connector-hard drive |
J2 |
|
20-pin data cable connector-drive 0 |
J3 |
|
20-pin data cable connector-drive 1 |
J4 |
|
5-pin connector-drive active LED |
J5 |
|
USER CONFIGURABLE SETTINGS | |||
|
Function |
Location |
Setting | |
| » |
Initial floppy data transfer rate is 500KHz |
W4 |
open |
|
Initial floppy data transfer rate is 250KHz |
W4 |
closed | |
| » |
Hardware drive select mode enabled |
W5 |
closed |
|
Firmware drive select mode enabled |
W5 |
open | |
| » |
Auto-deselect enabled |
W6 |
closed |
|
Auto-deselect disabled |
W6 |
open | |
| » |
Floppy drive precompensation is scaled by data rate: 500KHz=125ns, 300KHz=208ns, 250KHz=250ns |
W7 |
open |
|
Floppy drive precompensation is 125ns |
W7 |
closed | |
|
HARD DRIVE PORT ADDRESS | |||
|
Address |
W2 |
W3 | |
| » |
Port addresses are 1F0-1F7 3F03F7h |
open |
open |
|
Port addresses are 170-177 370377h |
closed |
closed | |