M K - 1 0 3 4 F C TOSHIBA NO MORE PRODUCED Native| Translation ------+-----+-----+----- Form 3.5"/SLIMLINE Cylinders 1354| 664| | Capacity form/unform 106/ MB Heads 4| 8| | Seek time / track 16.0/ 5.0 ms Sector/track 40| 39| | Controller IDE / AT Precompensation Cache/Buffer 64 KB Landing Zone Data transfer rate 1.600 MB/S int Bytes/Sector 512 5.900 MB/S ext Recording method RLL 2/7 operating | non-operating -------------+-------------- Supply voltage 5/12 V Temperature *C 50 | -40 60 Power: sleep W Humidity % | standby 0.5 W Altitude km | idle 2.5 W Shock g 5 | 75 seek 4.8 W Rotation RPM 3400 read/write 3.5 W Acoustic dBA spin-up 12.0 W ECC Bit 32,56 MTBF h 80000 Warranty Month Lift/Lock/Park YES Certificates ********************************************************************** L A Y O U T ********************************************************************** TOSHIBA MK-1034FC PRODUCT DESCRIPTION +---------------------------------------------------------+ | |XX Power | |XX 4 Pin | | | |XX I | |XX N |1-+PJ4 |XX T PJ11 || | |XX E || | |XX R |+-+ |XX F | |XX A | |XX C | |XX E | |XX | |XX | | | |XX Power +---------------------------------------------------------+ 3 Pin ********************************************************************** J U M P E R S ********************************************************************** TOSHIBA MK1034FC PRODUCT DESCRIPTION Jumper Setting ============== +--------------------------------------------------+ | +-------+ +---------+ | | | o o o | xxxxxxxxxxxxxxxxxxxxxxxx | o o o o | | +-+-1-2-3-+----------------------------+-4-3-2-1-+-+ | | +--- +5V | | | +--- +12 VDC | +----- +12V | | +----- +12V Return +------- +GND | +------- +5V Return +--------- +5 VDC PJ4 LED/Slave Present/Master/Slave/Drive Present/ECC/Auto Start --------------------------------------------------------------- +-----+ 1 o o 2 LED | o o | SLV PRS 5 o o 6 MST/SLV | o o | DRV PRS 9 o o 10 ECC | o o | DIS Auto Start +-----+ PJ4 LED -------- 1-2 CLOSED Connects the active signal to the HOST SLAVE/ACTIVE signal (PJ11-39) on the interface connector. This signal provides the capability to drive an external LED. An external current limiting resistor is required. PJ4 Slave Present ------------------ 3-4 CLOSED The HOST SLAVE/ACTIVE signal (PJ11-39) on the interface to the ground for the systems that require the slave drive to provide SLAVE PRESENT signal from the slave drive to a 2-drive system. This jumper PJ4-3/4 and PJ4-1/2 are mutually exclusive. Use should not install both jumpers. PJ4 Master/Slave ----------------- 5-6 CLOSED Drive is Master OPEN Drive is Slave PJ4 Slave Drive Present ------------------------ 7-8 CLOSED Slave drive is present In a 2-drive system, this jumper must be installed in the Master drive. PJ4 ECC -------- 9-10 CLOSED 4-Bytes ECC mode on Read and Write Long commands. OPEN 7-Bytes ECC PJ4 DIS Auto Start ------------------- 11-12 CLOSED The drive will be in STANDBY mode after power on. This means the spindle motor will not rotate and only the interface part is functioning. The drive will spin-up when a command is executed. The Auto Standby mode is not enabled by this jumper. OPEN The drive will be in Idle-1 mode after power on.