Card Type	Interface Converter
Chip Set	Unidentified
I/O Options	25-pin serial port (RS-232), network interface via RJ-45, RJ-11, 25-pin port or terminal block
Wiring Type	Unshielded twisted pair
Maximum Data Rate	115.2Kbps
Data Bus	External

CONNECTIONS
Function	Label	Function	Label
DTE/DCE serial port (25-pin connector)	CN1	UTP interface	CN2
Note: Network interface (CN2) is available with several connector options. Device may feature a terminal block, RJ-11, RJ-45, or 25-pin (male or female) connector.

USER CONFIGURABLE SETTINGS
Setting	Label	Position
DTE mode	S2	On
DCE mode	S2	Off

USER CONFIGURABLE SETTINGS
Setting		Label	Position
»	8ms RTS/CTS delay enabled	S1/3	On
	RTS/CTS delay disabled	S1/3	Off
»	Echo mode disabled	S1/4	Off
	Echo mode enabled	S1/4	On
»	Carrier controlled by RTS	S1/5	On
	Carrier forced high	S1/5	Off
»	Receive impedance set low (120Ohms)	S1/6	On
	Receive impedance set high (16kOhms)	S1/6	Off

TRANSMIT LINE IMPEDENCE
Setting		S1/1	S1/2
»	High impedence enabled	Off	Off
	Intermediate impedence enabled	On	On

2-WIRE/4-WIRE MODE SELECTION
Setting		S1/7	S1/8
»	2-wire mode enabled	On	On
	4-wire mode enabled enabled	Off	Off